Installation Guide
- EDGE iPhone 5/5s/SE/6/6s/7/8
- EDGE iPhone 6 Plus/7 Plus/8 Plus/X/XS/XS Max/XR
- Utomic GLASS
- Utomic RING
Clean corners with
alcohol wipe.
Dry corners with cloth.Do not touch the cleaned corners
Insert phone into
alignment sleeve.
Remove tab on each
EDGE protector.
Align EDGE protector
with cutout in sleeve.
Press down firmly against a
hard surface for 20 seconds.
Flip over and open sleeve.Handle your phone gently for the next 24 hrs. Periodically press down on your Edge protectors.
NOTE: While the Utomic Edge Protection System protectors significantly reduce damage to your phone from otherwise catastrophic drops, we do NOT recommend dropping or throwing your phone. No matter the cell phone case, a substantial drop of your phone may cause breaks including damage to internal components. Accidental damage may void your phone warranty and your Utomic 30 Day Limited Replacement Warranty. Please read our Policies for more details.
Instructions for Utomic EDGE for iPhone 6/7/8 Plus, X/XS, XS Max, and XR
Clean corners with
alcohol wipe.
Dry corners with cloth.Do not touch the cleaned corners
Insert phone into
alignment sleeve.
Remove tab on each
EDGE protector.Do not touch the adhesive.
Find the small Back Groove.
Align the Back Groove of
each EDGE protector with
back cutout in sleeve
and push onto phone.
Press down firmly against a
hard surface for 20 seconds.
Flip over and open sleeve.Handle your phone gently for the next 24 hrs. Periodically press down on your Edge protectors.
NOTE: While the Utomic EDGE Protection System protectors significantly reduce damage to your phone from otherwise catastrophic drops, we do NOT recommend dropping or throwing your phone. No matter the cell phone case, a substantial drop of your phone may cause breaks including damage to internal components. Accidental damage may void your phone warranty and your Utomic 30 DAy Limited Replacement Warranty. Please read our Policies for more details.
Clean screen with
alcohol wipe.
Dry screen
with cloth.
Optional - Remove any debris
with anti-dust sticker.
Remove the film from the
GLASS screen protector.Do not touch adhesive side.
Align GLASS to phone using the
cutouts and edges as guides.
Lightly place the GLASS on top of your phone screen without pressing down. When the GLASS has not bonded to your phone, you may guide it to the desired position by pushing gently along the edges of the GLASS.
Push down from at the middle of
GLASS to create a seal.
Once GLASS is in place, do not lift it up.
If an air bubble appears, press down on the bubble and push it towards the edge.
NOTE: Use caution when removing GLASS from your phone. If GLASS is broken or breaks during removal, handle with care as the GLASS screen protector may have sharp edges and corners.
- Locate the best location for your RING
- Apply your RING to your device. Press down for at least 10 seconds
- Wait 24 hours before spinning your RING around. Adhesive needs time to fully bond